The wrong governing load was calculated for check (the value was correct);
Read Grid Point Forces for beam + plate elements models (Ansys);
Poor performance when creating a new Job with a lot of steps (Ansys);
Stiffeners on custom sections were not recognized;
Constraints were not taken into account in Joint Finder (Ansys);
Display Beam Member Diagram and Moment Ratio diagram failed to display for beams with orientation node (Ansys);
Elements with topology Pyramids were not treated as Solid Elements. (Femap);
Fixed face5 normal calculation for solid elements in Wind Load (Femap);
Automatic highlight issues on Beam Member Finder and Weld Finder;
Change job selection affected Solution in Mechanical and changed state to out of date (Ansys);
Issue when imported groups/named selections;
Update formula in parameter Torsion Uf Closed (AISC 2010) to remove warning for open shapes about division on zero;
Weld Finder apply throat thickness t / 2 to all selected weld parts display a warning message;
Reference point options were not copied in Buoyancy Load (Femap);
An issue with remove load with references for Job of Jobs;
In Peak Finder / Governing Loads results were not shown for Load Set Content option for the following categories: Line/Plate Element Forces, Grid Point Forces, Strain Energy;
Dummy stiffeners were not saved into the project;
Report Designer:
Duplicated plots/tables were added for categories;
Edit Governing Loads tool;
Copy to Loads command ignored Fatigue Groups;
Selected materials in the Materials table were ignored;
Constraint plot used a default view and not selected views;
Preface SDC Verifier version changed from 20 to 2020;
An issue with imported results from Job;
Model Setup commands depended on selected items in the report tree;
A Project from the report was not saved if it has not been saved from the main window;
EN
DE