SDC Verifier 2020 known issues

SDC Verifier » Software » SDC Verifier » Known Issues » SDC Verifier 2020 known issues

  • The wrong governing load was calculated for check (the value was correct);
  • Read Grid Point Forces for beam + plate elements models (Ansys);
  • Poor performance when creating a new Job with a lot of steps (Ansys);
  • Stiffeners on custom sections were not recognized;
  • Constraints were not taken into account in Joint Finder (Ansys);
  • Display Beam Member Diagram and Moment Ratio diagram failed to display for beams with orientation node (Ansys);
  • Elements with topology Pyramids were not treated as Solid Elements. (Femap);
  • Fixed face5 normal calculation for solid elements in Wind Load (Femap);
  • Automatic highlight issues on Beam Member Finder and Weld Finder;
  • Change job selection affected Solution in Mechanical and changed state to out of date (Ansys);
  • Issue when imported groups/named selections;
  • Update formula in parameter Torsion Uf Closed (AISC 2010) to remove warning for open shapes about division on zero;
  • Weld Finder apply throat thickness t / 2 to all selected weld parts display a warning message;
  • Reference point options were not copied in Buoyancy Load (Femap);
  • An issue with remove load with references for Job of Jobs;
  • In Peak Finder / Governing Loads results were not shown for Load Set Content option for the following categories: Line/Plate Element Forces, Grid Point Forces, Strain Energy;
  • Dummy stiffeners were not saved into the project;
  • Report Designer:
    • Duplicated plots/tables were added for categories;
    • Edit Governing Loads tool;
    • Copy to Loads command ignored Fatigue Groups;
    • Selected materials in the Materials table were ignored;
    • Constraint plot used a default view and not selected views;
    • Preface SDC Verifier version changed from 20 to 2020;
    • An issue with imported results from Job;
    • Model Setup commands depended on selected items in the report tree;
    • A Project from the report was not saved if it has not been saved from the main window;
    • Disabled items were generated in the report;