SDC Verifier 2020.0.1 known issues

  • AISC360-10 Shear Check, rectangular built-up sections were not calculated;
  • Stress conversion issue for plate elements with negative normal;
  • AISC360-10 Torsional Check – warning for division on zero (open sections);
  • Wrong constraints nodes were read in the Joint Finder tool (Ansys);
  • Failed to calculate Governing Loads / Peak Finder for beams with mid-side node;
  • Break Page options in the report designer were not loaded correctly from the project file;
  • Governing Loads / Peak Finder for Line Element Forces (beam moments/forces) were based on Max result and not Absolute Maximum;
  • Elements without results (rigid, mass, etc.) in a classification plot were included (Femap);
  • Check Calculation Details failed to display for checks with replacements;
  • Plate Buckling module required Beam Buckling Module to load the project;
  • Report Designer. Import from other reports issue;
  • Break Page options in the report designer were not loaded correctly from the project file;